Labels:text | handwriting | parallel | screenshot | font | document | number OCR: Follow these easy instructions and you'll have a monitor hood built in 15 minutes or less. Materials: · Black foam core - 3/8" (9mm) thick (approx.) 4. Attach the fuzzy half of the adhesive · Ruler Velcro, with the strips parallel to · Velcro adhesive tape the inside edge of the hood. Attach · Black tape - 1" (25mm) wide the hook side of the Velcro strips to the monitor about 2" (5cm) in from 1. Measure your monitor across the top 6" (15cm) 8" (20cm) 8" (20cm) the edge and parallel with the edge. --- and down the side. 5. Place the monitor hood in position 2. Cut the pieces out of the foam core over the top of your monitor, taking as in the diagram. The top piece will care to line up the Velcro strips. Now be as long as the width of the monitor side side top - you're prepared for the most treach- and 8" (20cm) wide. The sides are as erous lighting conditions you're likely long as the monitor is high and taper to encounter. - - from 8" (20cm) to 6" (15cm) wide. 3. Tape the top piece to one of the This piece is as long as your monitor is tall. This piece is as long as your monitor is wide. side pieces to form a 90º angle. 8" (20cm) 6" (15cm) Velcro strips: Repeat with the second side piece. 8" (20cm) Tape: 12 13
